Toshiba Portege 2000 - Page 188

4 Replacement Procedures 4.11 Touch pad/ MODEM Jack/LED SW membrane
4-36 Portage 2000 Maintenance Manual (960-333)
4.11.3 LED SW membrane
Removing the LED SW membrane
The following describes the procedure for removing the LED SW membrane. (See Figure
4-26)
1. Lift the insulation sheet and remove the following screws fixing the LED SW
membrane and the LED lens.
• M2×3S S-THIN HEAD screw x3
• M2×4Z S-THIN HEAD screw x1
M2
×
3S S-THIN HEAD
LED lens
M2×4Z S-THIN HEAD
LED SW membrane
Figure 4-26 Removing the LED SW membrane
Installing the LED SW membrane
The following describes the procedure for installing the LED SW membrane. (See Figure
4-26)
1. Lift the insulation sheet and Install the LED SW membrane and the LED lens with
the following screws.
• M2×3S S-THIN HEAD screw x3
• M2×4Z S-THIN HEAD screw x1