Toshiba Portege M700 - MDC

Fehler! Formatvorlage nicht definiert. Fehler! Formatvorlage nicht definiert.
F
ehler! Formatvorla
g
e nic
h
4.23 MDC
Removing the MDC
The following describes the procedure for removing the MDC. (See Figure 4-40.)
1. Remove the following screws securing the MDC.
• M2.0×4.0B BIND screw ×2
2. Turn up the insulator.
3. Disconnect the MDC from the connector CN3010 on the system board.
4. Disconnect the MDC cable from the connector on the MDC.
MDC
MDC cable
CN3010
M2.0x4.0B BIND
Insulator
Modem jack
Figure 4-40 Removing the MDC
4-66 [CONFIDENTIAL] PORTÉGÉ M700/M750 Maintenance Manual (960-661)