Toshiba Portege R200 - Introduction to the Toshiba Portégé R200

4.7 Switch board 4 Replacement Procedures
PORTEGE R200 Maintenance Manual (960-519) [CONFIDENTIAL] 4-19
4.7 Switch board
Removing the Switch board
To remove the switch board, follow the steps below and refer to Figure 4-10.
1. Turn over the computer and remove the following screw.
• M2×8S BIND screw x1
2. Turn the computer face up and open the display.
3. Remove the switch cover.
4. Disconnect the switch cable from the connector CN3270 on the system board.
5. Remove the following screw and the switch board.
• M2×2.5C S-FLAT HEAD screw x1
Figure 4-10 Removing the switch board
Switch cover
Switch board
CN3270
Switch cable
M2×2.5C S-FLAT HEAD
M2×8S BIND