Toshiba Portege R200 - MDC Board; Figure 4-19 Removing the MDC Board

4 Replacement Procedures 4.12 MDC board
4-30 [CONFIDENTIAL] PORTEGE R200 Maintenance Manual (960-519)
4.12 MDC board
Removing the MDC board
To remove the MDC board, follow the steps below and refer to Figure 4-19.
1. Remove the following screws and disconnect the MDC board from the connector
CN3010 on the MP FPC.
• M2×3C S-FLAT HEAD screw x2
2. Disconnect the MDC cable from the connector on the MDC board.
Figure 4-19 Removing the MDC board
Installing the MDC board
To install the MDC board, follow the steps below and refer to Figure 4-19.
1. Connect the MDC cable to the MDC board.
2. Install the MDC board to the connector CN3010 on the MP FPC and secure it with
the following screws.
• M2×3C S-FLAT HEAD screw x2
M2×3C S-FLAT HEAD
M2×3C S-FLAT HEAD
CN3010
MDC board
MDC cable