Toshiba Portege R200 - Fan; Figure 4-22 Removing the Fan

4.15 Fan 4 Replacement Procedures
PORTEGE R200 Maintenance Manual (960-519) [CONFIDENTIAL] 4-33
4.15 Fan
Removing the Fan
To remove the fan, follow the steps below and refer to Figure 4-22.
1. Peel off the glass tape and disconnect the fan cable from the connector CN8770 on
the system board.
2. Remove the following screws and fan.
• M2×4C BIND screw x2
Figure 4-22 Removing the fan
Installing the Fan
To install the fan, follow the steps below and refer to Figure 4-22.
1. Install the fan and secure it with the following screws.
• M2×4C BIND screw x2
2. Connect the fan cable to the connector CN8770 on the system board and stick the
glass tape.
Glass tape
Fan
M2×4C BIND
M2×4C BIND
CN8770
Fan cable