Toshiba Portege R200 - System Board

4.20 System board 4 Replacement Procedures
PORTEGE R200 Maintenance Manual (960-519) [CONFIDENTIAL] 4-39
4.20 System board
Removing the System board
To remove the system board, follow the steps below and refer to Figure 4-27.
1. Disconnect the LCD cable and FL cable from the connectors CN5600 and CN5601
on the system board.
2. Disconnect the LED cable from the connector CN3260 on the system board (front).
3. Remove the following screws and system board.
• M2×3C S-FLAT HEAD screw x2
4. Remove the audio cover.