4.10 Touch pad 4 Replacement Procedures
4.10 Touch pad
Removing the Touch pad
To remove the touch pad, follow the steps below and refer to Figure 4-14.
1. Remove the touch pad fixed with the double-sided tape on the cover FAT assembly.
2. Turn the touch pad and disconnect touch pad cable from the touch pad assembly.
Connecto
Touch pad
Touch pad cable
Figure 4-14 Removing the touch pad
Installing the Touch pad
To install the touch pad, follow the steps below and refer to Figure 4-14 and Figure 4-15.
1. Connect the touch pad cable to the connector on the touch pad.
2. Stick a new double-sided tape touch pad and install the touch pad in place.
Guide
Figure 4-15 Installing the touch pad
CAUTION: Do not reuse the removed double-sided tape.
PORTÉGÉ R300 Maintenance Manual (960-591) [CONFIDENTIAL] 4-23
To Next Page
Loading...
