Toshiba PORTEGE R300 - LCD Unit

4.12 LCD unit 4 Replacement Procedures
4.12 LCD unit
Removing the LCD cable / Wireless LAN antenna cable / Bluetooth antenna
cable
To remove the LCD cable / Wireless LAN antenna cable / Bluetooth antenna cable, follow
the steps below and refer to Figure 4-17.
1. Disconnect the LCD cable from the connectors CN5601 on the system board.
2. Disconnect the Bluetooth antenna cable (only Bluetooth model).
3. Remove following screw fixed wireless LAN card cover.
• M2×4B S-THIN HEAD screw ×2 (for model without wireless LAN card cover)
• M2×4B Security torx screw ×1 (for models with wireless LAN card cover)
NOTE: Some models are not equipped with the wireless LAN card cover.
4. Disconnect the wireless LAN cable (white / black) and Bluetooth antenna cable
(only Bluetooth model).
Bluetooth antenna cable
LCD cable
Wireless LAN antenna cable
Wireless LAN card cover
(Some models are not equipped)
Harness holder
CN5601
Security torx
Figure 4-17 Removing the LCD cable / Antenna cables
PORTÉGÉ R300 Maintenance Manual (960-591) [CONFIDENTIAL] 4-25
All manuals and user guides at all-guides.com