Toshiba PORTEGE R300 - MDC (Modem Daughter Card)

4.22 MDC (Modem Daughter Card) 4 Replacement Procedures
4.22 MDC (Modem Daughter Card)
Removing the MDC jack
To remove the MDC jack, follow the steps below and refer to Figure 4-34.
1. Remove the MDC jack from the base assembly.
2. Peel the insulator and remove the MDC cable.
3. Remove the MDC cable to the cable guide.
Cable guide
Insulator
MDC cable
MDC jack
Figure 4-34 Removing the MDC jack
Installing the MDC jack
To install the MDC jack, follow the steps below and refer to Figure 4-34.
1. Install the MDC jack to the base assembly.
2. Set the MDC cable on the cable guide in place and stick the insulator.
PORTÉGÉ R300 Maintenance Manual (960-591) [CONFIDENTIAL] 4-43
All manuals and user guides at all-guides.com