3.20 ONLY ONE TEST 3 Tests and Diagnostics
NOTE: Make sure that this subtest is executed on the following condition:
1. Flat desk with vertical plane to get the stability of machine.
2. The vertical wall or plane is necessary.
3. Prevent the machine from shake or shock.
Vertical plane
Flat desk
Set the machine
against the vertical plane
with the Front upward
<Example>
The figure below shows the name and position of each side.
Top
(heaven surface)
PORTEGE R600 Maintenance Manual (960-709) [CONFIDENTIAL] 3-47
When this subtest is selected, the following message appears in the display.
Right side
Back
Front
Left side
The heaven surface establishes in the upper direction
Press [Enter] key
To Next Page
Loading...
