Toshiba Portege R600 - Base Assembly

4 Replacement Procedures 4.7 Base assembly
4.7 Base assembly
Removing the Base assembly
To remove the base assembly, follow the steps below and refer to Figure 4-7 and 4-8.
1. Loosen the screw fixing the access cover and remove the access cover.
2. Take out the tab under the cover.
3. Lift up the flip of the connector and disconnect the ExpressCard FPC from the
connector CN2110 on the system board while holding the tab.
Tab
Flip
ExpressCard FPC
CN2110
Screw
Access cover
Figure 4-7 Removing the base assembly (1)
4-18 [CONFIDENTIAL] PORTÉGÉ R600 Maintenance Manual (960-709)