4.11 Optical disk drive (DVD-Super Multi drive)/SD board 4 Replacement Procedures
4.11 Optical disk drive (DVD-Super Multi drive)/SD board
Removing the Optical disk drive/SD board
To remove the optical disk drive/SD board, follow the steps below and refer to Figure 4-13
to 4-15.
CAUTION: When the optical disk inside the optical disk drive can not be ejected
because of some failure, open the disc tray by inserting a slender object
(about 15 mm) such as a straightened paper clip into the eject hole near the
eject button.
1. Disconnect the SD board FPC from the connector CN9700 on the system board.
2. Stand the optical disk drive and remove the following screws.
• M2×3B S-THIN HEAD ×4
3. Slide the SD board outside and lift up the optical disk drive and SD board to
remove. (SD board FPC is fixed to the cover assembly by the double-sided tape.)
M2x3B S-THIN HEAD
SD board FPC
Optical disk drive
Guide
SD board
CN9700
Double-sided tape
M2x3B S-THIN HEAD
Figure 4-13 Removing the optical disk drive/SD board (1)
PORTÉGÉ R600 Maintenance Manual (960-709) [CONFIDENTIAL] 4-27
To Next Page
Loading...
