Toshiba Portege R600 - Sound Board;Microphone

4.16 Sound board/Microphone 4 Replacement Procedures
4.16 Sound board/Microphone
Removing the Sound board/Microphone
To remove the sound board/microphone, follow the steps below and refer to Figure 4-21 and
Figure 4-22.
1. Remove the following screw securing the sound board.
• M2×4C S-THIN HEAD ×1
2. Disconnect the sound board FPC and speaker harness from the connector CN9510
and CN6350 on the sound board and remove the sound board from the slot.
Speaker harness
Sound board FPC
Sound board
M2x4C S-THIN HEAD
CN6350
CN9510
Figure 4-21 Removing the sound board/microphone (1)
PORTÉGÉ R600 Maintenance Manual (960-709) [CONFIDENTIAL] 4-39