4.22 Cover assembly/LCD assembly 4 Replacement Procedures
Installing the Cover assembly/LCD assembly
To install the cover assembly/LCD assembly, follow the steps below and refer to Figure 4-30
to 4-33.
1. Set the PW SW button to the slot.
2. Set the SW board to the appli button.
3. Set the appli button to the slot.
4. Set the LCD assembly to the cover assembly and secure them with following screws.
• M2.5×4B FLAT HEAD ×2
NOTE: Insulators are not put on the back of a new COVER ASSY. Stick new insulators
as shown in the figure below.
Insulator
(HNS HLD CB INSULATOR)
Insulator
(COVER INSULATOR)
Insulator
(HNS HLD CA INSULATOR)
PORTÉGÉ R600 Maintenance Manual (960-709) [CONFIDENTIAL] 4-57
To Next Page
Loading...
