Toshiba Portege R600 - Touch Pad;Fingerprint Sensor Board

4.23 Touch pad/Fingerprint sensor board 4 Replacement Procedures
4.23 Touch pad/Fingerprint sensor board
Removing the Touch pad/Fingerprint sensor board
To remove the touch pad/fingerprint sensor board, follow the steps below and refer to Figure
4-34 and 4-35.
1. Disconnect the membrane switch FPC from the connector on the touch pad.
2. Disconnect the fingerprint sensor board FFC from the connector CN9810 on the
fingerprint sensor board.
3. Turn the cover assembly face up and remove the touch pad adhered with the double-
sided tape.
4. Remove the TP BTN cover adhered with the double-sided tape while releasing the
latches.
Touch pad
Fingerprint sensor
board FFC
Membrane switch FPC
TP BTN cover
CN9810
Latch
PORTÉGÉ R600 Maintenance Manual (960-709) [
CONFIDENTIAL] 4-59
Figure 4-34 Removing the touch pad/fingerprint sensor board (1)
Touch pad
Fingerprint sensor board