4 Replacement Procedures 4.12 Optical disk drive (DVD-Super Multi drive)/SD board
4-34 [CONFIDENTIAL] PORTÉGÉ R700 Maintenance Manual (960-833)
2. Remove the following screws securing the SD board.
• M2×3B S-THIN HEAD ×4
3. Disconnect the inner harness from the connector CN6070 on the back of the SD
board.
4. Push the gasket and lift up the optical disk drive and SD board to remove. (SD
board FPC is fixed to the cover assembly by the double-sided tapes (D-tape circle).)
Figure 4-20 Removing the optical disk drive/SD board (2)
SD board FPC
Optical disk drive
SD board
M2x3B S-THIN HEAD
Gasket
Inner harness
CN6070
MIC cover
To Next Page
Loading...
