4.26 Camera module 4 Replacement Procedures
PORTÉGÉ R700 Maintenance Manual (960-833) [CONFIDENTIAL] 4-83
Installing the Camera module
To install the camera module, follow the steps below and refer to Figure 4-49.
1. Stick a new D-stick tape to the LCD cover and peel off the separator.
NOTE: When replacing a LCD mask with a new one, stick a D-stick tape to the LCD
cover in place.
When sticking the D STICK TAPE, refer to the following figure.
2. Connect the camera harness to the connector on a new camera module and stick the
camera module to the slot of the LCD cover.
3. Arrange the camera harness in place.
To Next Page
Loading...
