Toshiba Portege R700 - Page 176

different at each country or region. When using these channels in any
country or region, refer to the section Approved Countries/Regions for use
in the printed user’s manual. The channel configuration is managed as
follows:
For wireless clients that operate in a Wireless LAN Infrastructure, the
Wireless LAN module will automatically start operation at the channel
identified by the Wireless LAN Access Point. When roaming between
different access points the station can dynamically switch to another
channel if required.
For Wireless LAN modules installed in wireless clients that operating
in a peer-to-peer mode, the module will use the default channel 10.
In a Wireless LAN Access Point, the Wireless LAN module will use the
factory-set default channel (printed in bold), unless the LAN
Administrator selected a different channel when configuring the
Wireless LAN Access Point device.
5GHz Band Channels Sets (Wireless IEEE 802.11
Revision a and n)
Frequency Range
Channel ID
5150-5850 MHz
34
5170*
2
36
5180*
2
38
5190*
2
40
5200*
2
42
5210*
2
44
5220*
2
46
5230*
2
48
5240*
2
52
5260*
2
56
5280*
2
60
5300*
2
64
5320*
2
100
5500*
2
104
5520*
2
108
5540*
2
112
5560*
2
PORTÉGÉ R700 / Satellite R630
User's Manual C-3