Toshiba Portege R830 - Removing the SSD (1.8-Inch) (1)

4.7 HDD/SSD 4 Replacement Procedures
PORTÉGÉ R830/Satellite R830 Maintenance Manual (960-880) [CONFIDENTIAL] 4-21
4.7.2 SSD (1.8-inch)
Removing the SSD (1.8-inch)
To remove the SSD (1.8-inch), follow the steps below and refer to Figure 4-7, 4-9 and 4-10.
1. Loosen the screws fixing the HDD/SSD cover.
2. Remove the HDD/SSD cover.
3. Peel off the insulators (SQUARE INSULATOR and SSD HOLD INSULATOR).
4. Disconnect the SSD FPC from the connector on the SSD.
5. Remove the SSD holder (with the SSD) from the slot.
Figure 4-9 Removing the SSD (1.8-inch) (1)
SSD FPC
SSD holder (with the SSD)
SQUARE insulator
SQUARE insulator
SSD HOLD insulator