Q9 ASD Installation and Operation Manual 163
Block Write Data 1
No Path — Direct Access Only
This parameter plays a role in the setup of the communications network by
establishing the type of data to be written to the ASD of the communications link.
The communications network includes other ASDs and Host/Control computers
that monitor the status of the ASD(s), transfers commands, and loads or modifies
the parameter settings of the ASD.
Changes made to this parameter require that the power be cycled (off then on) for
the changes to take effect.
Settings:
0 — None
1 — FA00 (Command 1)
2 — FA20 (Command 2)
3 — FA01 (Frequency)
4 — FA50 (TB Output)
5 — FA51 (Analog Output)
6 — FA13 (Speed)
Direct Access Number — F870
Parameter Type — Selection List
Factory Default — None
Changeable During Run — Yes
Block Write Data 2
No Path — Direct Access Only
This parameter plays a role in the setup of the communications network by
establishing the type of data to be written to the ASD of the communications link.
The communications network includes other ASDs and Host/Control computers
that monitor the status of the ASD(s), transfers commands, and loads or modifies
the parameter settings of the ASD.
Changes made to this parameter require that the power be cycled (off then on) for
the changes to take effect.
Settings:
0 — None
1 — FA00 (Command 1)
2 — FA20 (Command 2)
3 — FA01 (Frequency)
4 — FA50 (TB Output)
5 — FA51 (Analog Output)
6 — FA13 (Speed)
Direct Access Number — F871
Parameter Type — Selection List
Factory Default — None
Changeable During Run — Yes
F870 F871
To Next Page
Loading...
