Toshiba Q9+ - Page 236

224 https://www.toshiba.com/tic/
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
Communication Option (DeviceNet/Profibus) Setting 2
Program Communications Communication Options
While using the DeviceNet/Profibus communications protocol,
parameters F831 – F838 allow the user to select the ASD mem-
ory location that holds the Command/Frequency/Monitoring
instructions to be applied to the ASD for Communications Option
Settings 2 – 9, respectively.
See the DeviceNet Option Instruction Manual (P/N 58683) for
additional information on this parameter.
Direct Access Number —
F831
Parameter Type — Numerical
Factory Default — 0000h
Changeable During Run — Yes
Communication Option (DeviceNet/Profibus) Setting 3
Program Communications Communication Options
See F831 for information on this parameter.
Direct Access Number —
F832
Parameter Type — Selection List
Factory Default — 0000h
Changeable During Run — Yes
Communication Option (DeviceNet/Profibus) Setting 4
Program Communications Communication Options
See F831 for information on this parameter.
Direct Access Number —
F833
Parameter Type — Selection List
Factory Default — 0000h
Changeable During Run — Yes
Communication Option (DeviceNet/Profibus) Setting 5
Program Communications Communication Options
See F831 for information on this parameter.
Direct Access Number —
F834
Parameter Type — Selection List
Factory Default — 0000h
Changeable During Run — Yes
Communication Option (DeviceNet/Profibus) Setting 6
Program Communications Communication Options
See F831 for information on this parameter.
Direct Access Number —
F835
Parameter Type — Selection List
Factory Default — 0000h
Changeable During Run — Yes
Communication Option (DeviceNet/Profibus) Setting 7
Program Communications Communication Options
See F831 for information on this parameter.
Direct Access Number —
F836
Parameter Type — Selection List
Factory Default — 0000h
Changeable During Run — Yes
Communication Option (DeviceNet/Profibus) Setting 8
Program Communications Communication Options
See F831 for information on this parameter.
Direct Access Number —
F837
Parameter Type — Selection List
Factory Default — 0000h
Changeable During Run — Yes
Communication Option (DeviceNet/Profibus) Setting 9
Program Communications Communication Options
See F831 for information on this parameter.
Direct Access Number —
F838
Parameter Type — Selection List
Factory Default — 0000h
Changeable During Run — Yes
F831 – F841