Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
https://www.toshiba.com/tic/ 245
Monitor Output Function Command 11
Program My Function My Function Monitor
This parameter plays a role in the setup of the My Function fea-
ture by allowing the user to select the Maximum, Minimum, or
Normal (Avg.) value of the parameter F965 selection to be
recorded and output as a monitored function.
Settings:
0 — Normal
1 — Maximum
2 — Minimum
See the My Function Instruction Manual (P/N E6581335) for a
complete description of the setup requirements and operational
information of the Monitor Output Function parameter.
Direct Access Number —
F966
Parameter Type — Selection List
Factory Default — Normal
Changeable During Run — Yes
Monitor Output Function 21
Program My Function My Function Monitor
This parameter plays a role in the setup of the My Function fea-
ture by establishing the function that is to be recorded and out-
put as the Peak, Minimum, or Average value as selected at
parameter F968.
Select the Monitor Display Input Setting number from Table 14 on
page 260 to output the corresponding function.
Use the Communication Number if operating using communica-
tions.
See the My Function Instruction Manual (P/N E6581335) for a
complete description of the setup requirements and operational
information of the Monitor Output Function parameter.
Direct Access Number —
F967
Parameter Type — Selection List
Factory Default — 2000
Changeable During Run — Yes
Monitor Output Function Command 21
Program My Function My Function Monitor
This parameter plays a role in the setup of the My Function fea-
ture by allowing the user to select the Maximum, Minimum, or
Normal (Avg.) value of the parameter F967 selection to be
recorded and output as a monitored function.
Settings:
0 — Normal
1 — Maximum
2 — Minimum
See the My Function Instruction Manual (P/N E6581335) for a
complete description of the setup requirements and operational
information of the Monitor Output Function parameter.
Direct Access Number —
F968
Parameter Type — Selection List
Factory Default — Normal
Changeable During Run — Yes
F966 – F969
To Next Page
Loading...
