246 https://www.toshiba.com/tic/
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
Monitor Output Function 31
Program My Function My Function Monitor
This parameter plays a role in the setup of the My Function fea-
ture by establishing the function that is to be recorded and out-
put as the Peak, Minimum, or Average value as selected at
parameter F970.
Select the Monitor Display Input Setting number from Table 14 on
page 260 to output the corresponding function.
Use the Communication Number if operating using communica-
tions.
See the My Function Instruction Manual (P/N E6581335) for a
complete description of the setup requirements and operational
information of the Monitor Output Function parameter.
Direct Access Number —
F969
Parameter Type — Selection List
Factory Default — 2000
Changeable During Run — Yes
Monitor Output Function Command 31
Program My Function My Function Monitor
This parameter plays a role in the setup of the My Function fea-
ture by allowing the user to select the Peak, Minimum, or Normal
(Avg.) value of the parameter F969 selection to be recorded and
output as a monitored function.
See the My Function Instruction Manual (P/N E6581335) for a
complete description of the setup requirements and operational
information of the Monitor Output Function parameter.
Settings:
0 — Normal
1 — Maximum
2 — Minimum
Direct Access Number —
F970
Parameter Type — Selection List
Factory Default — Normal
Changeable During Run — Yes
Monitor Output Function 41
Program My Function My Function Monitor
This parameter plays a role in the setup of the My Function fea-
ture by establishing the function that is to be recorded and out-
put as the Peak, Minimum, or Normal (Avg.) value as selected at
parameter F972.
Select the Monitor Display Input Setting number from Table 14 on
page 260 to output the corresponding function.
Use the Communication Number if operating using communica-
tions.
See the My Function Instruction Manual (P/N E6581335) for a
complete description of the setup requirements and operational
information of the Monitor Output Function parameter.
Direct Access Number —
F971
Parameter Type — Selection List
Factory Default — 2000
Changeable During Run — Yes
F969 – F972
To Next Page
Loading...
