Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
https://www.toshiba.com/tic/ 83
Preset Speed 6
Program Frequency Preset Speeds
This parameter assigns an output frequency to binary number
0110 and is identified as Preset Speed 6. The binary number is
applied to S1 – S4 of the Terminal Board to output the Preset
Speed.
See F018 for additional information on this parameter.
Direct Access Number —
F023
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — Lower-Limit Freq.
(F013)
Maximum — Upper-Limit Freq.
(F012)
Units — Hz
Preset Speed 7
Program Frequency Preset Speeds
This parameter assigns an output frequency to binary number
0111 and is identified as Preset Speed 7. The binary number is
applied to S1 – S4 of the Terminal Board to output the Preset
Speed.
See F018 for additional information on this parameter.
Direct Access Number —
F024
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — Lower-Limit Freq.
(F013)
Maximum — Upper-Limit Freq.
(F012)
Units — Hz
F023 – F040
To Next Page
Loading...
