Tests and Diagnostics
Qosmio F60 Series Maintenance Manual (960-796 [CONFIDENTIAL]) 3-49
Subtest 03 USB
NOTE: When executing this subtest, USB test module and USB cable must be connected.
This subtest checks if USB port works properly.
The following menu appears in the display.
#################################################################
######## USB Port Select (XXXXXXXXX) #######
#################################################################
* *
* 0 ............ Port 0 (Front in the right side ) *
* 1 ............ Port 1 (Behind the right side) *
* 2 ............ Port 2 (Left side) *
* 9 ............ EXIT *
* *
*****************************************************************
.... Press test number[0,1,2, 9] ?
Connect the USB test module and USB cable to the computer.
Input the port test number and press Enter.
OK message appears in the display if the test ends without a defective.
NG message appears in the display if a defective is found during the test.
Confirm the connection of cable, then execute the test again.
Press 9 and return to ONLY ONE TESST menu.
Subtest 04 LED
This subtest checks if each LED lights properly.
The following message appears in the display in order. Follow the instructions
in the display to execute the test.
[HDD Access LED test]
Confirm the LED of HDD status blinks properly.
Press any key and following message appears in the display.
[Caps/Num/Overlay BT/W-LAN LED test]
Confirm each LED lights properly.
(1) Press [Caps Lock ] key ! ...Caps (on/off)
To Next Page
Loading...
Need help?
General
