User’s Manual 6-12
Power and Power-Up Modes
Connecting and disconnecting the Slice Expansion Battery
This battery pack increases your computer's operating time when a main
battery pack is also installed.
This section explains how to connect and disconnect the Slice Expansion
Battery, and begins with the removal process which is detailed through the
following steps.
Connecting the Slice Expansion Battery
To connect the Slice Expansion Battery to the computer, follow the steps
as detailed below:
1. Be sure the computer’s power is off and all cables are disconnected.
2. Close the display panel and turn the computer upside down.
3. Remove the protective cap from the Slice Expansion Battery.
4. Open latches on the Slice Expansion Battery and fit a tab on the battery
into the hole on the underside of the computer.
5. Connect the Slice Expansion Battery's connector to the docking port.
Figure 6-3 Seating the Slice Expansion Battery
When handling Slice Expansion Battery, be careful not to short circuit the
terminals. Also do not drop, hit or otherwise apply impact; do not scratch or
break the casing and do not twist or bend the latches of it.
Hole
Latches
Docking port
Tab
To Next Page
Loading...
