Toshiba R600 S4202 - Portege - Core 2 Duo 1.4 GHz - DC-In Harness

4 Replacement Procedures 4.15 DC-IN harness
4.15 DC-IN harness
Removing the DC-IN harness
To remove the DC-IN harness, follow the steps below and refer to Figure 4-20.
1. Disconnect the DC-IN harness from the connector CN8800 on the system board and
remove the DC-IN harness from the slot.
CN8800
Guide
DC-IN harness
Figure 4-20 Removing the DC-IN harness
Installing the DC-IN harness
To install the DC-IN harness, follow the steps below and refer to Figure 4-20.
1. Set the DC-IN harness into the guide of the slot and connect the DC-IN harness to
the connector CN8800 on the system board.
4-38 [CONFIDENTIAL] PORTÉGÉ R600 Maintenance Manual (960-709)