4
• Exposure of unit to water or other moisture before installation could result in
electric shock.
Do not store it in a wet basement or expose to rain or water.
•Afterunpackingtheunit,examineitcarefullyforpossibledamage.
•Donotinstalltheunitatplacewhereleakageofammablegasmayoccur.
Incasegasleaksandaccumulatesatsurroundingoftheunit,itmaycauseofre.
• Do not install in a place that can increase the vibration of the unit.
Do not install in a place that can amplify the noise level of the unit or where noise
and discharged air might disturb neighbors.
•Toavoidpersonalinjury,becarefulwhenhandlingpartswithsharpedges.
• Please read this installation manual carefully before installing the unit.
It contains further important instructions for proper installation.
• The manufacturer shall not assume any liability for the damage caused by not
observing the description of this manual.
REQUIREMENT OF REPORT TO THE LOCAL POWER SUPPLIER
Please make absolutely sure that the installation of this appliance is reported to
the local power supplier before installation. If you experience any problems or if the
installationisnotacceptedbythesupplier,theserviceagencywilltakeadequate
countermeasures.
■Important information regarding the refrigerant used
Thisproductcontainsuorinatedgreenhousegases.
Do not vent gases into the atmosphere.
Refrigerant type: R32
GWP
(1)
value: 675 * (ex. R32 ref. AR4)
(1)
GWP = global warming potential
The refrigerant quantity is indicated on the unit name plate.
* This value is based on F gas regulation 517/2014
1144180111-00_S04_182x257_40p_S_p70_220321.indd 4 22/03/21 8:19:33 AM