2
• Secure the outdoor unit with fi xing bolts and nuts if the unit is likely to be
exposed to a strong wind.
• Use Ø8 mm or Ø10 mm anchor bolts and nuts.
• If it is necessary to drain the defrost water, attach drain nipple 9 and cap
water proof ! to the bottom plate of the outdoor unit before installing it.
Fixing bolt arrangement of outdoor unit
Insert the cushion between the indoor
unit and wall, and tilt the indoor unit for
better operation.
For the rear left and left piping
Insulate the refrigerant pipes separately
with insulation, not together.
2
3
8
4
Make sure to run the drain hose sloped
downward.
Do not allow the drain hose to get slack.
The auxiliary piping can be connected to
the left, rear left, rear right, right, bottom
right or bottom left.
Rear
right
Right
Bottom
right
Rear
left
Bottom left
Left
6 mm thick heat resisting
polyethylene foam
1
Batteries Flat head
wood screw
Remote control holder
Vinyl tape
Apply after carrying
out a drainage test.
Wireless remote control
Saddle
Extension
drain hose
(Not available,
provided by installer)
Shield pipe
(Attach to the front panel.)
Air fi lter
Hook
Installation
plate
Hook
65 mm or more
170 mm or more
170 mm or more
600 mm or more
100 mm or more
45 mm or more
400 mm or more
600 mm or more
5
Filter
Part
code
Parts name Q’ty
A
Refrigerant piping
Liquid side : Ø6.35 mm
Gas side : Ø9.52 mm
One
each
B
Pipe insulating material
(polyethylene foam, 6 mm thick)
1
C
Putty, PVC tapes
One
each
Optional Installation Parts
INSTALLATION DIAGRAM OF INDOOR AND OUTDOOR UNITSINSTALLATION DIAGRAM OF INDOOR AND OUTDOOR UNITS
Remark :
• Detail of accessory and installation parts can see in
the accessory sheet.
• Some pictures might be different from the actual parts.
415 mm
69 mm
50 mm
240 mm
Drain outlet
Air outlet
Air inlet
Wall
Cut the piping
hole sloped
slightly.
01_1115551134-EN.indd 201_1115551134-EN.indd 2 1/13/2558 BE 2:36 PM1/13/2558 BE 2:36 PM
To Next Page
Loading...
