Toshiba RAS-07S3KHS-EE - How to Take off the Front Panel; Wiring Connection

4
Stripping length of the power supply cord
NOTE
• Use stranded wire only.
• Wire type : H07RN-F or 60245 IEC66 (1.5 mm
2
or more).
For the air conditioner with the power supply cord
• If the power supply cord is damaged, it must be replaced by the
manufacturer, the service agency, or another similarly qualifi ed person
in order to avoid hazard.
CAUTION
• Be sure to refer to the wiring system diagram labeled inside the front
panel.
• Check local electrical cords and also any specifi c wiring instructions or
limitations.
CAUTION
How to install the air inlet grille on the indoor
unit
• When attaching the air inlet grille, the contrary of the removed operation is
performed.
NOTE
• Use stranded wire only.
• Wire type : H07RN-F or 60245 IEC66 (1.5 mm
2
or more).
3
1
2
Air inlet grille
Front panel
Taking out the power cord
• Put the power supply cord through
the notch.
Notch
3
4
Stripping length of the connecting cable
Screw
Terminal cover
Cord clamp
Earth line
Screw
100 mm
90 mm
10 mm
10 mm
110 mm
Connecting cable
about 20 cm
Connecting cable cord
Power supply cord
Earth line
Power supply terminal
block (L, N, )
Plastic wired guide
Connecting terminal
block (1, 2, 3, 4, )
Plastic wired
guide
10 mm
120 mm
10 mm
L
N
Power supply terminal
block (L, N, )
Cord clamp
Terminal cover
Screw
Screw
Power supply cord
Earth line
N
L
40 mm
10 mm
10 mm
30 mm
Wiring Connection
Wiring of the power cord can be carried out without removing the front
panel.
(1) Take off the air inlet grille.
(2) Remove the terminal cover and the cord clamp.
(3) Protrude power cord about 15 cm from the back body.
(4) Securely connect the Earth line to fi rst then secure connect the Live
line to L and Neutron line to N.
(5) Tighten fi rmly but not over 1.2 N·m (0.12 kgf·m).
(6) Put the power supply cord through the notch.
How to connect the power cord
After connected the power cord completely.
(1) Protrude connecting cable about 20 cm from the back body.
(2) Securely connect the Earth line to fi rst then secure connect the
connecting cable to terminal 4, 3, 2 and 1.
(3) Tighten fi rmly but not over 1.2 N·m. (0.12 kgf·m).
(4) Secure the power cord and connecting cable with the cord clamp.
(5) Secure the terminal cover and air inlet grille on the Indoor or secure the
front panel, air inlet grille and then fi x its by screws in case front panel
take off.
(6) Make sure connect the same terminal number between Indoor and
Outdoor unit.
How to connect the connecting cable
How to take off the Front panel
(1) Open the air inlet grille upward.
(2) Remove two screws of the front panel.
(3) Slightly open the lower part of the front panel then pull the upper part of
the front toward you to remove it from the rear plate.
01_1115551134-EN.indd 401_1115551134-EN.indd 4 1/13/2558 BE 2:36 PM1/13/2558 BE 2:36 PM