Evaporator 1) Follow the procedure in item
-
(Heat exchanger) 2) Remove 2 fixing screws at the left
side of the end plate of the heat exchanger.
3) Remove 2 fixing screws on the right
side of heat exchanger.
4) Move unit from the wall by pushing
at point as picture and lift up the unit.
5) Rotate unit to back side, then remove the
Pipe-holder from the main unit.
6) Rotate the main unit, then pull out the
Heatexchanger from the Back-body
as picture.
No. Part name Work procedure Remarks
PUSH
PUSH
8
1
6
Fixing screw
Fixing screw
ā 109 ā
FILE NO. SVM-14017
To Next Page
Loading...
