Toshiba RAS-13NAX-V - Installation Diagram of Indoor and Outdoor Units

 – 36 –
FILE NO. SVM-06001
8-2. Installation Diagram of Indoor and Outdoor Units
For the rear left and left
piping
Insert the cushion between
the indoor unit and wall,
and tilt the indoor unit for
better operation.
Wall
Do not allow the drain hose
to get slack.
Make sure to run the drain
hose sloped downward.
Cut the piping hole
sloped slightly
Shield
pipe
A
ir
f
ilt
e
r
H
o
o
k
Hook
(A
tta
c
h
to
th
e
fr
o
n
t p
a
n
e
l.)
65 mm or more
170 m
m
or m
ore
1 Installation
plate
170 mm or more
5 Sasa-Zeolite
Vitamin C filter
6Bio-enzyme &
The auxiliary piping can be
connected the left, rear left,
rear right, right, bottom right
or bottom left.
Right
Rear right
Bottom right
Left
Rear left
Bottom left
Gingko filter
2 Wireless remote
control
8 Pan head wood screw
4 Remote control holder
Insulate the refrigerant
pipes separately with
insulation, not together.
6 mm thick heat resisting
polyethylene foam
100 mm or more
from wall
Vinyl tape Apply
after carrying out
a drainage test
Extension
drain hose
(Not available,
provided by installer)
600 mm or more
600 mm or more
100 m
m
or m
ore
from
w
all
Saddle
600 m
m
or m
ore
from
w
all
As show in the figure, hang
power cord and connecting
cable downward, and take out it
along piping connection port.
33
33
3 Batteries
22
22
2 Wireless remote control
Cover
Before installing the
wireless remote control
 With the remote control cover
open, load the batteries supplied
polarity.
correctly observing their
·