2222
ENEN
44 Wash and then dry.Wash and then dry.
(1) (1) Soak in hot Soak in hot water at water at 40 to 40 to 50°C for 50°C for about 10 about 10 to 15 to 15 minutes. Iminutes. If the f the staining is staining is particularlyparticularly
severe, use a washing detergent compound (weak basic or neutral) at 10 to 15 timessevere, use a washing detergent compound (weak basic or neutral) at 10 to 15 times
the standard concentration.the standard concentration.
(2) (2) Rub up and Rub up and down, and down, and rub left rub left and right. and right. Also, rub Also, rub the surfthe surface gently ace gently with a with a sponge.sponge.
(3) (3) Rinse Rinse with with running running water.water.
(4) (4) Shake Shake thoroughlythoroughly, a, and allond allow w the the unit unit to to drain.drain.
(If oil or smoke strains are par(If oil or smoke strains are particularly hard to remove, repeat steps (1) to (4) 2 or ticularly hard to remove, repeat steps (1) to (4) 2 or 33
times.)times.)
(5) (5) Dry Dry thoroughly thoroughly in in the the shade.shade.
55
Attach the plasma pure fiAttach the plasma pure filter.lter.
•• GrasGrasp the handlep the handles, and thes, and then insert as shon insert as shown inwn in aa. Insert into the right and left guide rails,. Insert into the right and left guide rails,
and then press in the direction and then press in the direction ofof bbafter it is all after it is all the way in.the way in.
•• Press both Press both ends of ends of the plasma the plasma pure filter pure filter in the in the direction ofdirection of ccuntil the protrusions on bothuntil the protrusions on both
sides of the plasma pure filter are completely sides of the plasma pure filter are completely inserted into the holders.inserted into the holders.
Press in the plasma pure filter until the Press in the plasma pure filter until the protrusions on both sides are completely inserprotrusions on both sides are completely insertedted
into the holders. If into the holders. If installation is incomplete, the FILTER indicator (orange) may light.installation is incomplete, the FILTER indicator (orange) may light.
66 Attach the air filter, and then close the air inlet grille.Attach the air filter, and then close the air inlet grille.
CAUTION
CAUTION
•• NevNever use any proer use any products maducts marked as “brked as “bleach”leach”..
•• Do not attDo not attempt tempt to disasso disassemble temble the unithe unit..
•• Do not rub with a scruDo not rub with a scrubbing brusbbing brush or similah or similar implemer implement.nt.
•• Do not utiliDo not utilize washze washing deving devices or equiices or equipmentpment..
•• Do not dry with a hair dryer or Do not dry with a hair dryer or other appliance that uses other appliance that uses hot air. (hot air. (The heat can cause the uThe heat can cause the unitnit
to deform.)to deform.)
•• After cleaning, wait After cleaning, wait until the unit is completely until the unit is completely dried before attaching. The FIdried before attaching. The FILLTER indicatorTER indicator
may turn on if the unit may turn on if the unit is used while wet.is used while wet.
22
11
33
HolderHolder
ProtrusionProtrusion
Plasma pure filterPlasma pure filter
To Next Page
Loading...
