Toshiba RAS-16SAVP-E - USING THE REMOTE CONTROLLER; Signal Transmission and Placement; Remote Controller Holder Installation; Controller Mounting and Removal


77 ENEN
E
E
NN
GG
LL
II
SS
HH
FF
RR
AA
NN
ÇÇAA
II
SS
DD
EE
UU
TT
SS
CC
HH
II
TT
AA
LL
II
AA
NN
OO
EE
SS
PP
AA
ÑÑ
OO
LL
ΕΕ
ΛΛ
ΛΛ
ΗΗ
ΝΝ
ΙΙ
ΚΚ
ΗΗ
PP
OO
RR
TT
UU
GG
UU
ÊÊ
SS
##
##
##
SS
WW
##
##
##
##
##
##
RR
UU
##
##
##
Check that the air filter Check that the air filter and the plasma pure filter are correctly installedand the plasma pure filter are correctly installed
•• Press the plasmPress the plasma pure filter a pure filter until the projectiuntil the projections on both sons on both sides are fully ides are fully inserted into theinserted into the
holders (tabs). If the holders (tabs). If the installation is not correct, the installation is not correct, the FILFILTER indicator (orange) may comeTER indicator (orange) may come
on.on.
Location of the remote Location of the remote controllercontroller
•• Keep the Keep the remote controller remote controller where its signals where its signals can reach the can reach the receiver of receiver of the indoorthe indoor
unit (a distance of up to unit (a distance of up to 7 m is allowed).7 m is allowed).
•• When you select When you select timer operation, timer operation, the remote contthe remote controller automatically trroller automatically transmits aansmits a
signal to the indoor unit asignal to the indoor unit at the specified time.t the specified time.
If you keep the remote controller in a location where proper signal transmission isIf you keep the remote controller in a location where proper signal transmission is
blocked, a time lag of blocked, a time lag of up to 15 up to 15 minutes may occur.minutes may occur.
Remote controller holderRemote controller holder
Installing the remote controller holderInstalling the remote controller holder
•• Before you Before you actually install the remote actually install the remote controller holder on a wall or controller holder on a wall or pillar, checpillar, checkk
whether the remote controller signals can be received by the indoor whether the remote controller signals can be received by the indoor unit.unit.
Mounting and removing the remote Mounting and removing the remote controllercontroller
•• TTo mount the remote co mount the remote controller, hold it pontroller, hold it parallel to the remote contarallel to the remote controller holder androller holder and
push it in push it in fullyfully. To remov. To remove the remote controller, slide e the remote controller, slide the remote controllerthe remote controller
upwards and out from the holder.upwards and out from the holder.
USING THE REMOTE CONTROLLER
USING THE REMOTE CONTROLLER
CAUTIONCAUTION
•• The air conditioner will not operate The air conditioner will not operate if curtains, doors or other if curtains, doors or other objects block thobjects block the signals from the remote ce signals from the remote controller to the indoorontroller to the indoor
unit.unit.
•• Be careful Be careful that liquids that liquids do not sdo not spill onto tpill onto the remote he remote controller.controller.
•• Do not eDo not expose the remotxpose the remote controller to e controller to direct sunlight or direct sunlight or heat.heat.
If the infrared signal receiver on the indoor unit If the infrared signal receiver on the indoor unit is exposed to direct sunlight, the air conditioner may not function properly.is exposed to direct sunlight, the air conditioner may not function properly.
Use curtains Use curtains to prevent sunlight from reaching the to prevent sunlight from reaching the receiver.receiver.
•• Signals may not Signals may not be properly received, if thbe properly received, if the room using the air conditioner e room using the air conditioner has fluorescent lighting with electhas fluorescent lighting with electronic starters. Ifronic starters. If
you plan to use fluorescent lamps, consult with your local dealer.you plan to use fluorescent lamps, consult with your local dealer.
•• If other electrical appliances are activated by the remIf other electrical appliances are activated by the remote controller, moote controller, move these appliances or consult with your local dealerve these appliances or consult with your local dealer..
ProjectionsProjections
7 m7 m