– 30 –
FILE NO. SVM-08032
Vinyl tape
Apply after carrying
out a drainage test.
Saddle
Extension
drain hose
(Not available,
provided by installer)
100 mm or more
100 mm or more
600 mm or more
600 mm or more
100 mm or more
600 mm or more
600 mm or more
600 mm or more
600 mm or more
100 mm or more
Extension
drain hose
(Not available,
provided by installer)
Shield pipe
Air fi lter
Hook
Hook
170 mm or more
50 mm or more
170 mm or more
18 Class 24 Class
1 Installation
plate
(
A
t
t
a
c
h
t
o
t
h
e
f
r
o
n
t
p
a
n
e
l
.
)
For the rear left and left piping
Insert the cushion between the
indoor unit and wall, and tilt the
indoor unit for better operation.
Do not allow the drain hose
to get slack.
Make sure to run the drain
hose sloped downward.
Cut the piping
hole sloped
slightly.
The auxiliary piping can be
connected to the left, rear left,
rear right, right, bottom right
or bottom left.
Right
Rear right
Left
Bottom right
Rear
left
Bottom left
Insulate the refrigerant pipes
separately with insulation, not
together.
8 mm thick heat resisting
polyethylene foam
8 Pan head
wood screw
3 Batteries
5
6
2 Wireless remote control
Remote control holder
4
Before installing the wireless remote controller
• Loading Batteries
1. Remove the battery cover.
2. Insert 2 new batteries (AAA type)
following the (+) and (
-
) positions.
3 Batteries
2 Wireless remote controller
A
C
L
8-2. Installation Diagram of Indoor and Outdoor Units
Wall
Super Oxi Deo filter
Super Sterilizer filter
To Next Page
Loading...
