Toshiba RAS-22 - Troubleshooting; Remote Control A-B Selection; Remote Control B Setup

TROUBLESHOOTING (CHECK POINT)
19
The unit does not operate. Cooling or Heating is abnormally low.
●Thepowermainswitchis
turned off.
● The circuit breaker is
activated to cut off the
powersupply.
● Stoppage of electric
current
● ON timer is set.
●Thefiltersareblockedwithdust.
● The temperature has been set improperly.
●Thewindowsordoorsareopened.
● The air inlet or outlet of the outdoor unit
is blocked.
●Thefanspeedistoolow.
● The operation mode is FAN or DRY.
●POWERSELECTIONfunctionisset
75%or50%(This function is
depend on remote controller).
To separate using of remote control for each indoor unit in case of 2 air
conditioners are installed nearly.
Remote Control B Setup.
1. Press RESET button on the indoor unit to turn the air conditioner ON.
2. Point the remote control at the indoor unit.
3. Push and hold buttonontheRemoteControlbythetipofthe
  pencil.“00”willbeshownonthedisplay.(picture1)
4. Press during pushing .“B”willshowonthedisplayand
  “00”willdisappearandtheairconditionerwillturnOFF.TheRemote
  ControlBismemorized.(picture2)
Note: 1.RepeatabovesteptoresetRemoteControltobeA.
   2.RemoteControlAhasnot“A”display.
   3.DefaultsettingofRemoteControlfromfactoryisA.
REMOTE CONTROL A-B SELECTION
20
1 2
1120650287-00_S01_182x257_12p_S_p70_210716.indd 6 2/5/2022 10:28:00 AM