– 37 –
FILE NO. SVM-06021
8-4. Indoor Unit
8-4-1. Installation place
• A place which provides the spaces around the
indoor unit as shown in the above diagram.
• A place where there is no obstacle near the air inlet
and outlet.
• A place that allows easy installation of the piping to
the outdoor unit.
• A place which allows the Front panel to be opened.
CAUTION
• Direct sunlight or fluorescent light to the indoor
unit's wireless receiver should be avoided.
• The microprocessor in the indoor unit should not
be too close to RF noise sources.
(For details, see the owner's manual.)
<Remote control>
• A place where there are no obstacles such as a
curtain that may block the signal from the indoor
unit.
• Do not install the remote control in a place exposed
to direct sunlight or close to a heating source, such
as a stove.
• Keep the remote control at least 1 m apart from the
nearest TV set or stereo equipment. (This is
necessary to prevent image disturbances or noise
interference.)
• The location of the remote control should be
determined as shown below.
<Remote control usage>
• Under Ceiling Installation
Fig. 8-4-1
• Console Installation
Fig. 8-4-2
NOTICE
The Paper pattern is inside the package box cover.
Do not bend and dispose of it before installing.
* Axial distance
7 m
*7 m
Reception range
Reception range
Remote control
Remote control
Ceiling
Wall
5 m
5 m
* Axial distance
Reception
range
Remote control
Remote control
7 m
*7 m
Reception range
Wall
Floor
5 m
5 m
To Next Page
Loading...
