– 38 –
Ear
th line
20 mm
10 mm
80 mm
110 mm
<How to remove the drain cap>
Clip drain cap with needle-nose pliers, and pull out.
Fig. 8-4-9
<How to remove the drain hose>
The drain hose is secured in place by a screw.
Remove the screw securing the drain hose, then pull
out the drain hose.
Die-cutting
Front panel slit
Changing
drain hose
Piping preparation
Rear right
Rear left
Bottom left
Left
Bottom right
Right
1
2
3
Cord clamp
Terminal block
Terminal cover
Screw
Earth line
Screw
Connecting cable
Connecting cable
Stripping length of the connecting cable
ab
out
1
5 c
m
Fig. 8-4-6
Heat insulator
Drain hose
Fig. 8-4-10
Fig. 8-4-7
FILE NO. SVM-10049
1. Die-cutting front panel slit
Cut out the slit on the left or right side of the front
panel for the left or right connection and the slit
on the bottom left or side of thefront panel for the
bottom left or right connection with a pair of
nippers.
2. Changing drain hose
For left connection, left-bottom connection and
rear-left connection’s piping, it is necessary to
relocate the drain hose and drain cap.
Fig. 8-4-8
CAUTION
• Be sure to refer to the wiring system diagram
labeled inside the front panel.
• Check local electrical regulations for any
specific wiring instructions or limitations.
8-4-5. Piping and Drain Hose Installation
<Piping and drain hose forming>
• Since condensation results in machine trouble,
make sure to insulate both the connecting pipes
separately.
(Use polyethylene foam as insulating material.)
CAUTION
NOTE :
• Use stranded wire only.
• Wire type : H07RN-F or more
To Next Page
Loading...