10
EN
Press this button to start the electrical air purifying operation.
During air conditioner operation
a PURE button
Pressing this button starts PURE operation.
• The PURE indicator (blue) on the display panel of the indoor unit turns on.
• Plasma pure filter and air ionizer are activated.
To stop only PURE operation
PURE button
Pressing this button stops PURE operation.
• The PURE indicator (blue) on the display panel of the indoor unit turns off.
• Plasma pure filter and air ionizer are deactivated.
To stop air conditioner operation at the same time
button
Pressing this button stops air conditioner operation and PURE operation.
• The OPERATION indicator (green) and PURE indicator (blue) on the display panel of
the indoor unit turn off.
When the air conditioner is stopped
a PURE button
Pressing this button starts PURE operation.
• The PURE indicator (blue) on the display panel of the indoor unit turns on.
INFORMATIONINFORMATION
• The air ionizer starts in conjunction with air purifying operation.
• During the air purifying operation, a small amount of ozone is produced, and you might notice the smell.
• When the air flow is automatic, it changes between LOW and MED+ .
LOW operation is performed when the indoor air becomes clean. During operation, the position of the vertical air flow louvers may
change if the room temperature is low.
• Opening the front panel during PURE operation sometimes turns on the FILTER indicator (orange).
In this case, stop PURE operation (stop the air conditioner if it is also operating), and then close the front panel.
• The FILTER indicator (orange) turns on after PURE operation is performed for about 1000 hours.
When the indicator turns on, clean the plasma pure filter. () see page 21.)
PURE OPERATION
CAUTION
• When the button is pressed the next time, operation starts with the combined
air conditioner and PURE operation.
• During the combined air conditioner and PURE operation, air conditioner operation
only cannot be stopped.
AUTO
PRESET
CLOCK
To Next Page
Loading...
