Item
16. Remote-A or B
selection
Operation flow and applicable data, etc.
Description
1. Purpose
This operation is to operate only one
indoor unit using one remote controller.
2. Description
When operating one indoor unit in a
situation where two indoor units have
been installed in the same room or
nearby rooms, this operation prevents the
remote controll signal from being
received simultaneously by both units,
thus preventing both units from operating.
3. Operation
The indoor unit on which the remote
controll selection has been set to B
receives the signal of the remote control
also set to B.
(At the factory the remote controller
selection is set to A on all the indoor
units. There is no A setting display.)
To separate using of remote control for each indoor
unit in case of 2 air conditioner are installed nearly.
Remote Control B Setup.
1. Push and hold button on the Remote
Control by the tip of the pencil.
Note : 1. Repeat above step to reset Remote Control
to be A.
2. Remote Control A has not "A" display.
3. Default setting of Remote Control from
factory is A.
(Picture 2).
"00" will be shown on the display
(Picture 1
).
2. Press during pushing . "B" will show
on the display and "00" will disappear and the
air conditioner will turn OFF. The Remote
Control B is memorized
Unit B setup.
Press and hold MODE button for more than 20
seconds.
When A setup changed to B setup : 5 beeps will
sound and operation lamp blinks for 5 seconds.
When B setup changed to A setup : 5 beep will
sound.
To Next Page
Loading...
