Decorative Fabric Installation
The decorative fabric for cover on the air inlet grille of indoor unit was put in
the accessories. User can use it as required.
The method of installation is as follows.
1. Remove the air inlet grille.
Open the air inlet grille upward and pull it toward you.
As shown on ¿ gure as below.
Air inlet grille
2. Prepare the fabric that you choose for install.
3. Insert the fabric into the left and right side of the air inlet grille and adjust
corner position of decorative fabric is smooth.
Attach the hook and loop of velcro tape fully together.
As shown on ¿ gure as below.
Velcro loop
Velcro hook
Fabric
"
Decorative fabric
4. Insert the fabric into the top and bottom side of the air inlet grille.
Attach the hook and loop of velcro tape fully together.
As shown on ¿ gure as below.
Velcro loop
Velcro hook
Fabric
5. Reassembly the air inlet grille by reverse process of 1.
NOTE
• The tightness of the fabric depends on attaching the hook and loop of
velcro around the air inlet grille, take appropriate action.
CAUTION
• If clean decorative fabric by washing, it may affect to appearance and
¿ tting of the decorative fabric.
• Recommend to use vacuum cleaner to removing the dusts from
decorative fabric.
14
To Next Page
Loading...