For dehumidif cation, a moderate cooling performance is controlled automatically.
1. Press
MODE
: Select Dry .
2. Press : Set the desired temperature.
DRY OPERATION
8
To automatically control room temperature and airf ow for faster cooling operation
(except in DRY and FAN ONLY mode)
Press
Hi POWER
: Start and stop the operation.
In case of the misplaced or discharged remote control
• Pressing the RESET button, the unit can start or stop without using
the remote control.
• Operation mode is set on AUTOMATIC operation, preset temperature is
and fan operation is 25°C automatic s peed.
Set the timer when the air conditioner is operating.
Setting the ON Timer Setting the OFF Timer
1
Press : Set the desired
ON timer.
Press : Set the desired OFF
timer.
2
Press : Set the timer. : Set the timer.
3
Press : Cancel the timer. : Cancel the timer.
Daily timer allows the user to set both the ON & OFF timers and will be
activated on a daily basis.
Setting Daily Timer
1
Press : Set the ON timer.
3
Press .
2
Press : Set the OFF timer.
4
Press : button during the
(
or ) mark f ashing.
• During the daily timer is activating, both arrows (
, ) are indicated.
Note:
• Keep the remote control in accessible transmission to the indoor unit;
otherwise, the time lag of up to 15 minutes will occur.
• The setting will be saved for the next same operation.
This function is used when its circuit breaker is shared with other electrical
appliances. It limits the maximum current/power consumption to 100%, 75%
or 50%. The lower the percentage, the higher the saving and also the longer
the compressor lifetime.
Press
POWER-SEL
: Select (for 100%), (for 75%), (for 50%)
• When the level is selected, PWR-SEL level f ashes on LCD display for 3 seconds.
In case of 75% and 50% level, number “75” or “50” also f ashes for 2 seconds.
• Due to the reason that POWER SELECT FUNCTION limits the maximum
current, inadequate cooling capacity may occur.
Hi-POWER OPERATION
9
POWER-SELECTION OPERATION
10
TEMPORARY OPERATION
11
TIMER OPERATION
12
Press
Press
Set your preferred operation for future use. The setting will be memorized by the
unit for future operation (except airf ow direction).
1. Select your preferred operation.
2 . Press and hold
for 3 seconds to memorize the setting.
The mark displays.P
3. Press
: Operate the preset operation.
To automatically restart the air conditioner after the power failure (Power of the
unit must be on.)
Setting
1. Press and hold the RESET button on the indoor unit for 3 seconds to set
the operation. (3 beep sound and OPERATION lamp blink 5 time/sec for
5 seconds)
2. Press and hold the RESET button on the indoor unit for 3 seconds to
cancel the operation. (3 beep sound but OPERATION lamp does not
• In case of ON timer or OFF timer are set, AUTO RESTART
OPERATION does not activate.
To operate at super low fan speed for quiet operation (except in DRY mode)
Press
QUIET
: Start and stop the operation.
Note: Under certain conditions, QUIET operation may not provide adequate
cooling due to low sound features.
For comfortable sleep, automatically control air f ow and automatically turn OFF.
Press
: Select 1, 3, 5 or 9 hrs for OFF timer operation.
Note: The cooling operation, the set temperature will increase automatically
1 degree/hour for 2 hours (maximum 2 degrees increase).
Firstly, turn off the circuit breaker.
Indoor Unit and Remote Control
• Clean the indoor unit and the remote control with a wet cloth when needed.
• No benzine, thinner, polishing powder or chemically-treated duster.
To protect bad smell caused by the humidity in the indoor unit.
1. If the
button is pressed once during “Cool” or “Dry” mode,
the fan will continue to run for other 30 minutes, then it will turn off
automatically. This will reduce the moisture in the indoor unit.
2. To stop the unit immediately, press the
more 2 times within
30 seconds.
PRESET OPERATION
13
AUTO RESTART OPERATION
14
QUIET OPERATION
15
COMFORT SLEEP OPERATION
16
MAINTENANCE
17
SELF CLEANING OPERATION (COOL AND
DRY OPERATION ONLY)
18
blink)
4. Reinstall the air filters and close the air inlet grille.
1. Open the air inlet grille.
2. Remove the air filters.
3. Vacuum or wash and then dry them.
Air filters
Clean every 2 weeks.
1. Three-minute protection feature: To prevent the unit from being activated
for 3 minutes when suddenly restarted or switched to ON.
2. Some minor cracking sound may occur when unit operating. This is
normal because the cracking sound may be caused by expansion/
Air conditioner operating conditions
Temp.
Operation
Outdoor Temperature
Cooling
- 10°C ~ 46°C
21°C ~ 32°C
Dry
- 10°C ~ 46°C
17°C ~ 32°C
OPERATION AND PERFORMANCE
19
contraction of plastic.
Room Temperature
2
To Next Page
Loading...
