4
TEMPORARY OPERATION / VOLTAGE SETTING
TEMPORARY switch (COOL, AUTO)
When you can’t use the remote controller temporarily due to missing, etc., temporary operation can be per-
formed on the switch panel.
• Setting the TEMPORARY switch to “AUTO” starts the automatic operation, to “COOL” starts the cooling
operation (LOW), respectively.
• Setting the TEMPORARY switch to “AUTO” or “COOL”, the operation can’t be performed from the remote
controller.
To stop the temporary operation, set the switch to “AUTO RESTART OFF”.
Voltage setting
The most suitable voltage can be set up by combining the VOLTAGE SELECT 1 with 2 when adjusting the
voltage on the spot.
(Do not touch the switches at the installation time because an installation dealer will adjust them.)
(Both are available.)
Voltage select 1/Voltage select 2
Supply voltage
220V
230V
240V
220V/230V 240V
220V 230V
AB
AUTO RESTART
OFF ON
TEMPORARY
COOL AUTO
VOLTAGE1
VOLTAGE2
220V/230V 240V
220V 230V
VOLTAGE1
VOLTAGE2
220V/230V 240V
220V 230V
VOLTAGE1
VOLTAGE2
220V/230V 240V
220V 230V
220V 230V
VOLTAGE1
VOLTAGE2
REMOCON
To Next Page
Loading...
