O
NAMES AND FUNCTIONS OF INDICATIONS ON REMOTE CONTROLLER
Display
All indications, except for clock time indication, are indicated by pushing the START/STOP button.
1
Transmission mark
This transmission mark indicates when the
remote controller transmits signals to the indoor
unit.
2
Mode display
Indicates the current operation mode.
(AUTO : Automatic control, A : Auto changeover
control,
: Cool, : Dry, : Heat, : Fan
only)
3
Temperature display
Indicates the temperature setting (17°C to 30°C).
When you set the operating mode to : Fan
only, no temperature setting is indicated.
4
FAN speed display
Indicates the selected fan speed. AUTO or one
of five fan speed levels (LOW
, LOW
+
,
MED
, MED
+
, HIGH ) can be
indicated.
Indicates AUTO when the operating mode is
either AUTO or
: Dry.
5
TIMER and clock time display
The time set for timer operation or clock time is
indicated.
The present time is always indicated except for
TIMER operation.
6
High power display
Indicates when the High power operation starts.
Push the Hi-POWER button to start and push it
again to stop the operation.
7
P
(MEMORY) display
Flashes for 3 seconds when the MEMO button is
pushed during operation.
P
mark is indicated when the button is not
pushed for more than 3 seconds while the mark
is flashing.
Push another button to turn off the mark.
8
ECO TIMER display
Indicates when the ECO TIMER is in operation.
Each time you push the ECO button, the display
changes in the sequence of 1, 3, 5, or 9h.
9
A, B change indication remote controller
Push the “CHK” point and “MODE” button at
once, for changing remote controller setting from
“A” to “B”. (Priority is given to “A” setting.)
The switch panel of indoor unit is also changed
to “B” setting.
• In the illustration, all indications are indicated for
explanation.
During operation, only the relevant indications will
be indicated on the remote controller.
To Next Page
Loading...
