9-9. Connection of Electric Wires
When you connect the wires to the terminals, be sure to loosen the parts box before work.
If an incomplete connection is done, a contact failure may be caused and resulted in a danger of an electric
shock and so on.
Work under condition that the parts box is loosened : Work under condition that the parts box is fixed :
9-10. Voltage Setting
The most suitable voltage can be set up by combining the VOLTAGE SELECT 1 with 2 when adjusting the voltage
on the spot.
(Do not touch the switches at the installation time because an installation dealer will adjust them.)
Correct way Incorrect way
To Next Page
Loading...
