Manual address setup procedure
While the operation stops, change the setup.
(Be sure to stop operation of the unit).
Procedure 1
Push simultaneously
+ + buttons for 4
seconds or more. After a while, the display part
flashes as shown below. Check the displayed CODE
No. is [10].
• When the CODE No. is other than [10], push
button to erase the display and repeat procedure
from the first step.
(After pushing
button, operation of the remote
controller is not accepted for approx. 1 minute).
(For group control, No. of the first displayed indoor
unit becomes the header unit).
Procedure 2
Every pushing
button, the indoor unit No. in
the group control is displayed in order. Select the
indoor unit of which setup is changed.
In this time, the position of the indoor unit of which
setup is changed can be confirmed because fan of
the selected indoor unit operate.
Procedure 3
1. Using temp. setup
buttons, specify CODE
No. [12].
(CODE No. [12]: Line address).
2. Using timer time
buttons, change the line
address from [3] to [2].
3. Push
button.
In this time, the setup finishes when the display
changes from flashing to lighting.
Indoor unit No. before setup change is displayed.
Procedure 4
1. Using temp. setup
buttons, specify
CODE No. [13].
(CODE No. [13]: Indoor address)
2. Using timer time
buttons, change the
indoor address form [3] to [2].
3. Push
button.
In this time, the setup finishes when the display
changes from flashing to lighting.
Indoor unit No. before setup change is displayed
Procedure 5
1. Using temp. setup
buttons, specify
CODE No. [14].
(CODE No. [14]: Group address).
2. Using timer time
buttons, change the
setup data from [0001] to [0002].
(Setup data [Header unit: 0001] [Follower unit:
0002])
3. Push
button.
In this time, the setup finishes when display
changes from flashing to lighting.
Indoor unit No. before setup change is displayed
(* Display changes according to
the model No. of indoor unit.)
To Next Page
Loading...
