Toshiba RAV-HM1101KRTP-E - Cooling;heating;fan only operation; Dry operation

OM_1123950201_EN-Book.indd 17 11/6/2562 BE 16:23
HOW TO USE REMOTE CONTROLLER
Ŷ
Cooling/heating/fan only operation
6WDUW
6:,1* )$1
4
3
1
2

67$576723EXWWRQ 
3UHVVWKLVEXWWRQWRVWDUWWKHDLUFRQGLWLRQHU

0RGHVHOHFWEXWWRQ02'(
6HOHFW&RRO +HDW RU)DQRQO\ 

7HPSHUDWXUHEXWWRQ 
6HWWKHGHVLUHGWHPSHUDWXUH
:KHQWKHDLUFRQGLWLRQHULVLQ)$121/<RSHUDWLRQ
WKHWHPSHUDWXUHGLVSOD\LVQRWLQGLFDWHG

)DQVSHHGEXWWRQ)$1
6HOHFWRQHRI /2: /2:

 
0('
0('

 +,*+ 
 The OPERATION lamp on the display panel
of the indoor unit goes on. And operation starts
after approximately 3 minutes. (If you select FAN
ONLY mode, the unit will start immediately.)
 The
: Fan only mode does not control
temperature.
 Fan speed is the same as
HIGH .
Therefore, perform only steps 1, 2 and 4 to
select this mode.
6WRS
67$576723EXWWRQ 
3UHVVWKLVEXWWRQDJDLQWRVWRSWKHDLUFRQGLWLRQHU
NOTE
When the indoor unit is operated together with
a cooling only outdoor model outdoor unit, 
appears on the remote controller but the heating
operation is disabled.
Ŷ
Dry operation
6WDUW
6:,1* )$1
3
1
2

67$576723EXWWRQ 
3UHVVWKLVEXWWRQWRVWDUWWKHDLUFRQGLWLRQHU

0RGHVHOHFWEXWWRQ02'(
6HOHFW'U\ 

7HPSHUDWXUHEXWWRQ 
6HWWKHGHVLUHGWHPSHUDWXUH
 The fan speed display indicates .
 The OPERATION lamp on the display panel
of the indoor unit lights, and operation starts after
approximately 3 minutes.
6WRS
67$576723EXWWRQ 
3UHVVWKLVEXWWRQDJDLQWRVWRSWKHDLUFRQGLWLRQHU
2ZQHUҋV0DQXDO
6
9-EN
- 9 -