Installation Manual
‒ 33 ‒
33-EN
Group control
Simultaneous twin system
A combination with an outdoor unit allows
simultaneous ON / OFF operation of the indoor
units.
The following system patterns are available.
- Two indoor units for the twin system
T Twin system
Outdoor unit
Indoor unit
Remote controller
Indoor unit
Finish of address setup by power-ON
• For wiring procedure and wiring method, follow
to the “Electrical connection” in this manual.
• When the power supply has been turned on,
the automatic address setup starts and which
indicates that address is being set up flashes on
the display part.
During setup of automatic address, the remote
controller operation is not accepted.
Required time up to the finish of automatic
addressing is approx. 5 minutes.
Adjustment of air direction
1. Using the remote controller switch, change the
up/down air direction by moving the horizontal
louver.
2. Adjust the right/left air direction by bending the
vertical grille inside of the air outlet port with
hands.
REQUIREMENT
Do not touch the horizontal louver directly with
hands; otherwise a trouble may be caused.
For handling of the horizontal louver, refer to
“Owner’s Manual” attached to the outdoor unit.
To Next Page
Loading...
