Installation Manual
‒ 35 ‒
35-EN
Manual address setting
1
Push and hold menu button and [ ] setting button simultaneously for 10 seconds or more.
2
Push OFF timer button to confirm the selected indoor unit.
<Line address>
3
Push the menu button until the Code No. flashes. And using the [ ] [ ] buttons, specify the Code
No.
[12].
4
Push the menu button until the Set data flashes. And using the [ ] [ ] buttons, set a line address.
5
Push OFF timer button to confirm the Set data.
<Indoor unit address>
6
Push the menu button until the Code No. flashes. And using the [ ] [ ] buttons, specify the Code
No.
[13].
7
Push the menu button until the Set data flashes. And using the [ ] [ ] buttons, set an indoor unit
address.
8
Push OFF timer button to confirm the Set data.
<Group address>
9
Push the menu button until the Code No. flashes. And using the [ ] [ ] buttons, specify the Code
No.
[14].
10
Push the menu button until the Set data flashes. And using the [ ] [ ] buttons, set a group
address. If the indoor unit is individual, set the address to 0000. (header unit: 0001, follower unit:
0002)
11
Push OFF timer button to confirm the Set data.
12
When all the settings have been completed, push ON/OFF button to finish the settings.
(Return to the normal mode)
To find an indoor unit’s position from its address
1
Push and hold menu button and [ ] setting button simultaneously for 10 seconds or more.
E.g.) A unit number 1-1 is indicated on the LCD of the remote controller. The indicated number
shows the line (system) address and indoor unit address of the unit.
2
When 2 or more indoor units are connected to the remote controller (group-controlled units),
a number of other connected units appears each time you push the [
] [ ] buttons.
3
Push the ON/OFF button, return to the normal mode.
To Next Page
Loading...
