Toshiba RB-RWS21-E - Special Operations; Self Clean Operation; Menu Navigation

–8–
EN
Installation Manual
Basic wiring diagram
NOTE
Terminals of A and B have no polarity.
 Note
• It takes some time before the remote controller becomes operable when the power is turned on. This is not a
malfunction.
<When the power is turned on the remote controller>
It takes about 1 minute before the remote controller becomes operable.
• For the operation of switching the room temperature sensor and the settings of the test operation, refer to the
page 20.
To diverge from the indoor unit To diverge from the Header remote controller
Remote control wiring
(Locally procured)
0.5 mm
2
to 2.0 mm
2
.
Remote controller
(Header)
Remote controller
(Follower)
(Sold
separately)
Terminal block
for the remote
control wiring
Earth
Indoor unit
AB AB
AB
Remote control wiring
(Locally procured)
0.5 mm
2
to 2.0 mm
2
.
Remote controller
(Header)
Remote controller
(Follower)
(Sold
separately)
Terminal block
for the remote
control wiring
Earth
Indoor unit
AB AB
AB
Power on
“ ” flashes
“”
disappears
Remote controller becomes
operable.
About 1
minute